National Clothesline

The use of the syringe and needle glue applicator can be perfected by practicing the application of the glue bead on a simulated open hem made from a piece of paper.

The amount of pressure needed on the syringe and the speed with which the needle is drawn across the hemline to get a 1 ⁄16-inch wide bead will quickly be determined.

Then the technique can be used once the needle is inserted through the lining and behind the hem flap. As described, gluing cuffs and hems that are sewn to the lining is best done by using the syringe and needle applicator.

Practice gluing garments by using a piece of paper in place of the leather (see photo).

Determine how much pressure to apply to the plunger to get the permanent glue to flow out of the needle. Move the needle in a straight line as you push on the plunger. Try to get the Perma Hold glue to flow on to the paper so that it forms a 1 ⁄16-inch bead which will become a 1⁄4-inch wide film when the hem is placed together. Practice until you feel comfortable gluing with the syringe and needle.

With this practice under your belt, proceed to glue up the nearest hem or cuff that is sewn to the lining. Insert the needle through the lining at the point where the leather ends.

Then move the needle as far from the point of insertion as possible before applying pressure to the plunger to deposit a 1 ⁄16-inch bead of Perma Hold glue along the hemline. Repeat in the opposite direction.

Warning: Do not apply any side pressure to the needle or it will snap off at the end of the syringe and get glue where you don ’t want it.

Recommendation: Dull the point of the needle before using it to apply the Perma Hold glue. This will prevent it from catching as you move it after inserting through the lining and into the hemline (see photo).

If you don't get enough glue into the hem it will not glue together properly. If you get too much into the hemline it will take much longer to dry and may bleed through the skin, making the hemline stiff and hard.

You can check the amount of Perma Hold glue you are depositing. As you apply the glue, try to slide the hem between your thumb and forefinger. If it doesn't slide, there is not enough glue. It it just slides, it is OK If it slides like a greased pig, you used too much glue.

When you pull the needle out from the hemline through the line, be sure that you have pulled the plunger back slightly to release the pressure and stop the flow.

Should you accidentally get the Perma Hold glue on the lining or the suede, do not let it dry. Immediately wipe up the excess with a paper towel or absorbent cloth. Then wipe up the residue with a moist damp cloth and allow it to air dry.

If the glue dries before you notice it, it must be worked with an appropriate spotter that normally would not harm the skin. Dried glue on suede should be removed with abrasive spotters and Spot-Wiz VDS.